3.5 hp tecumseh engine manual12/29/2022 To avoid carbon monoxide poisoning, be sure engine is outdoors in a well-ventilated area. Three- Prong Wall Receptacle is not available at the location where your starter will be used, one must be installed by a Licensed Electrician BEFORE USING THE ELECTRIC STARTER. If your house wiring is grounded and a G.F.I. Three- Wire Grounded System, DO NOT USE THIS ELECTRIC STARTER UNDER ANY CONDITION. If your house wiring does not have a G.F.I. Determine if your house wiring has a Ground Fault Interrupted (G.F.I.) Three-Wire Grounded System if you are not sure ask a Licensed Electrician. Be sure fuel valve, if present (see equipment manufacturer’s instructions) is open. Avoid creating any source of ignition until fuel vapors are gone. Replace anti-splash fuel fill cap securely and wipe up spilled fuel before starting engine. Leave space in the tank to allow fuel to expand without overflowing. Using an approved red GASOLINE container, add fuel slowly, being careful to avoid spilling. Afterward, continue reading instructions below. Clean area around fuel fill cap and remove fuel fill cap. Be sure engine is outdoors and in a well-ventilated area. Stop engine and allow it to cool before refueling. Check engine and equipment before each operation for loose nuts, bolts and attachments keep these items tightened. Be sure ignition switch on engine or equipment is in “ON”, “RUN” or “START” position. Screw oil fill cap/plug back into oil fill hole. Add oil to overflow point, making sure to avoid spilling. Screw oil fill cap/dipstick back into oil filler tube. If oil reading on dipstick is below “ADD” mark, slowly add oil to reach “FULL” level. Unscrew and remove oil fill cap/dipstick from oil filler tube. Unscrew oil fill cap/dipstick from oil filler tube and wipe dipstick clean. Adult Supervision of Operation, Refueling and Maintenance
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |